Chiller Replacement for Assisted Living Facilities in South Florida
In an assisted living facility, cooling is not a comfort item. Older residents are more sensitive to heat, many take medications that make it harder for the body to cool down, and a hot building in a South Florida summer can turn into a health problem in a matter of hours. If your facility runs on a chiller and that chiller is getting old, planning its replacement before it fails is one of the most important things you can do.
We work on chillers, cooling towers and the electrical that feeds them across Broward, Palm Beach and Miami Dade. Here is what ALF owners and administrators should know.
Signs your chiller is near the end
Chillers in South Florida run most of the year, so they wear out faster than in cooler places. These are the signs we look for:
The chiller is 20 to 25 years old or more.
It uses an older refrigerant like R 22 or R 123 that is being phased out and getting expensive.
Repairs are coming more often and costing more each time.
It cannot keep the building cool on the hottest afternoons.
Tube leaks, compressor problems or control failures keep coming back.
Energy bills keep climbing even though nothing in the building changed.
One of these alone does not always mean replacement. Several together usually does.
Why ALFs need a plan, not an emergency
When a chiller fails in an office building, people go home. When it fails in an ALF, the residents are home. Florida's rules for assisted living facilities already require an emergency power plan that keeps the building at a safe temperature, and the state takes heat in these buildings seriously. A chiller failure in July is the worst time to start shopping for equipment, because lead times on large chillers can run months.
Planning ahead lets you pick the right equipment, line up temporary cooling, get permits approved and schedule the work in the cooler months when the load is lower.
Planning the replacement
Look at the whole plant. The chiller is only one part. Pumps, the cooling tower, piping, valves and controls all need a look. Replacing the chiller and leaving a tired cooling tower in place often just moves the problem.
Size it right. Many older chillers were sized for a building that has changed since. A load review tells you whether the new unit should be bigger, smaller or split into two machines for backup. Two smaller chillers can keep part of the building cool if one goes down, which is worth a lot in an ALF.
Plan temporary cooling. For most facilities, the residents stay in place during the work. That means a rental chiller, a staged changeover or doing the swap during a mild stretch of weather. This has to be worked out before the old unit is disconnected.
Get it in the building. Chillers are big. We check the rigging path, crane access and any structural or roof work needed before ordering.
Do not forget the electrical and the generator
A new chiller often has different electrical needs than the old one. The feeders, the starter or drive and the disconnect may all need to change. If the chiller or part of the cooling plant is on the generator, the new load has to fit what the generator can carry and still meet the facility's emergency power plan.
This is where it helps to have one contractor for both trades. We hold an HVAC license (CAC1825204) and an electrical license (EC13006438), so the mechanical and electrical sides are planned together instead of discovered at startup.
Repair or replace
Sometimes a major repair makes sense, like a compressor rebuild on a chiller that is otherwise in good shape. But if the chiller is old, uses a phased out refrigerant and keeps breaking, money spent on repairs is usually money you will not get back. A proper evaluation should give you both options with honest numbers on each.
Frequently asked questions
How long does a chiller replacement take in an assisted living facility?
The install itself can be a short window, but the full project including design, permits and equipment lead time often takes months. That is why planning early matters.
Can residents stay in the building during a chiller replacement?
In most cases, yes. Temporary cooling or a staged changeover keeps the building comfortable while the new chiller goes in.
Should we replace the cooling tower at the same time?
If the tower is near the end of its life, doing both together usually saves money and downtime. If it is in good shape, it can stay.
Do we need to upgrade electrical for a new chiller?
Often. The new unit may need different feeders, a new starter or drive and a review of the generator load if it is on emergency power.
Talk to us about your chiller
Pacman HVAC Electric Fire has worked on commercial buildings across South Florida since 1999 from 751 Shotgun Rd in Sunrise. See our chiller and HVAC replacement page, then call 954.577.7923, Monday to Friday 7 AM to 5 PM, or request a quote.




Comments